Teac IF-FW/DM - Manual (Page 3)

O
TASCAM IF-FW/DM Owner's Manual
Introduction
The IF-FW/DM provides the following inter-
facing between your TASCAM mixer and a
host computer via FireWire:
• 24 channels of Input to the mixer from the
computer at 44.1k and 48k sample rates
• 24 channels of Output from the mixer to
the computer at 44.1k and 48k sample
rates
• 1 MIDI port In and Out from the com-
puter
Features
Macintosh
• OS: MacOS X 10.3.5 or higher
• Computer: Apple Macintosh series with
on-board FireWire
• Minimum: G4/800 MHz
• Recommended: Dual G4/1 GHz or higher
• Memory (RAM): 256MB or more
Windows
• OS: Microsoft® Windows® XP Home
Edition or XP Professional with Service
Pack 2
• Computer: Windows® XP Compatible
PC equipped with an IEEE 1394/FireWire
Port
• Minimum: Pentium®, Celeron®, or
Pentium® compatible processor 1.5 GHz
or higher
• Recommended: Pentium® IV/2 GHz or
higher
• Memory (RAM): 256MB or more
DM-3200 Requirements
The DM-3200 must be running software
V1.20 or higher to use the IF-FW/DM.
Please refer to www.tascam.com to obtain
this update. Do not proceed to install the
IF-FW/DM until your DM-3200 is running
V1.20 or higher.
DM-24 Requirements
The DM-24 must be running V3.00 software
to use the IF-FW/DM. Please refer to www.
tascam.com or your local service center to
obtain this update. Do not proceed to install
the IF-FW/DM until your DM-24 is running
V3.00 or higher.
System Requirements
Windows and Windows XP are trademarks
of Microsoft Corporation.
Macintosh, MacOS, MacOS X and FireWire
™ are trademarks of Apple Computer.
All other trademarks are the property of their
respective holders.
Trademarks