Teac US-224 Windows Drivers - Manual (Page 2)

To install under Win2K or Windows XP:
Note: Run the Installer with US-224 turned OFF.
Double click on the executable file US224_Win2k_Install_3_08.exe. The installer will
run.
Click the "Setup" button. The Welcome dialog box will appear.
Click the "Next" button. The driver files will be installed to your hard drive.
NOTE: You may be prompted by a message informing you that the software you are about
to install does not have a digital certificate. Simply click “Continue the installation anyway”
and continue.
Connect the US-224 to the computer, plug it in, and turn it on. The Windows plug-n-play
will notice a new USB device and start the Add New Hardware wizard, which will find the
three needed files on its own. This will take about 30-60 seconds.
The drivers are now installed and the US-224 is ready to operate.
To install using Windows New Hardware Wizard:
Unzip the driver files into a new (empty) folder on the hard disk. (If you're installing the
drivers from the CD-R, you can ignore this step.)
Connect the US-224 to the computer, plug it in and turn it on
The Windows plug-n-play will notice a new USB device and start the Add New Hardware
wizard.
Choose "Search for a suitable driver for my device" and press Next
Enter the path where the drivers are stored and press OK
After Windows finds the "firmware download" driver, click Next
Click "Finish" · The other driver components will be automatically discovered and loaded
Click "Finish" if prompted, and reboot if prompted