SVSi N8000 Control API - Manual (Page 8)

8 N8000 Series Direct Control API www.svsiav.com
N4321 Audio Transceiver
wppriority Sets the priority for a specific window. WP IP, window number,
priority number wppriority 169.254.120.2 1
1<┘
wpbordon Turns on the border on a specific window. WP IP, window number wpbordon 169.254.120.2
1<┘
wpbordoff Turns off the border on a specific window. WP IP, window number wpbordoff 169.254.120.2
1<┘
wppreset Activates an internal preset. WP IP, preset number wppreset 169.254.120.2 0<┘
N4321 Audio Transceiver
Command Description Required Variables Example
atrswitch Switches audio on the ATR to a specified source. ATR IP, source IP atrswitch 169.254.252.121
169.254.30.238<┘
atrmute Mutes the ATR's output. ATR IP atrmute
169.254.252.121<┘
atrunmute Turns off mute on the ATR's output. ATR IP atrunmute
169.254.252.121<┘
atrtxmute Disables the ATR's transmit output. ATR IP atrtxmute
169.254.252.121<┘
atrtxunmute Enables the ATR's transmit output. ATR IP atrtxunmute
169.254.252.121<┘
atrhpvol Sets the ATR's headphone volume level (0-100). ATR IP, volume number atrhpvol 169.254.252.121
50<┘
atrlovol Sets the ATR's lineout volume level (0-100). ATR IP, volume number atrlovol 169.254.252.121
75<┘
atrlovolup Increments the lineout volume by the given value (e.g., if volume is
currently 40 and the command is to increment by 5, this will make
the new volume 45). ATR IP, amount to increase atrlovolup 169.254.252.121
5<┘
atrlovoldown Decrements the lineout volume by the given value. ATR IP, amount to decrease atrlovoldown
169.254.252.121 5<┘
atrhpvolup Increments the headphone out volume by the give value. ATR IP, amount to increase atrhpvolup
169.254.252.121 5<┘
atrhpvoldown Decrements the headphone out volume by the given value. ATR IP, amount to decrease atrhpvoldown
169.254.252.121 5<┘
openrelay Opens a specific relay on the ATR (relay number = 1 or 2). ATR IP, relay number openrelay 169.254.43.21 1
closerelay Closes a specific relay on the ATR (relay number = 1 or 2). ATR IP, relay number closerelay 169.254.43.21 1
Video Wall Commands
Command Description Required Variables Example
videowall Changes a video wall layout (Decoders or with Windowing
Processors) to the new layout. Name of video wall, name of
layout videowall "myVidWall"
"fullScreen"<┘
videowall Changes one window within the video wall to a new source. Can be
referenced by IP or stream number. Name of video wall, name of
layout, layer to switch, stream
number (or IP of Encoder) videowall "myVidWall"
"fullScreen" 1 123<┘
Miscellaneous Commands
Command Description Required Variables Example
script Executes the stored script. Script must be saved to N-Command
prior to executing. Script ID script 33<┘
N2510 Windowing Processor (Continued)
Command Description Required Variables Example