SVSi N8000 Control API - Manual (Page 5)

5 N8000 Series Direct Control API www.svsiav.com
Decoder Commands
Decoder Commands
Command Description Required Variables Example
N-Series
Support V-Series
Support
switch Switches Decoder video stream by IP
address. If Decoder audio follows is
enabled, this will switch the audio stream
as well. Decoder IP and
Encoder IP switch 169.254.104.1 169.254.105.1 <┘ Y Y
switch Switches Decoder video stream by
Encoder stream number. If Decoder
audio follows is enabled, this will switch
the audio stream as well. Decoder IP and
Encoder stream
number switch 169.254.104.1 212 <┘ Y Y
switchaudio Switches Decoder audio stream by IP
address. This will only switch the audio
stream.
Note: Decoder will have an * next to its
name in the matrix when the device is
not set to audio follow video. Decoder IP and
Encoder IP switchaudio 169.254.104.1
169.254.105.1 <┘ Y Y
switchaudio Switches Decoder audio stream by
Encoder stream number. This will only
switch the audio stream.
Note: Decoder will have an * next to its
name in the matrix when the device is
not set to audio follow video. Decoder IP and
Encoder stream
number switchaudio 169.254.104.1 212 <┘ Y Y
audiofollow Sets the Decoder back to audio follow
mode. If currently listening to a different
audio stream, box will immediately
switch to current video stream’s audio.
Can also be accomplished by sending a
switchaudio command to set to stream 0. Decoder IP audiofollow 169.254.104.1 <┘ Y Y
live Sets Decoder to live play mode. Decoder IP live 169.254.104.1 <┘ Y Y
local Activates a local playlist. Valid Options
are 1-8. Check device limitations (some
devices only support playlist 1). Decoder IP AND
playlist number local 169.254.30.238 1<┘ Y Y
serial Sends stored serial command
(referenced by CommandID #) to device
at IP address. Decoder IP and
serial command ID serial 169.254.17.88 29<┘ Y Y
serialhex Sends raw serial command (HEX) to
device through N-Command. Wait time
determines time for N-Command to
automatically ask for the response from
the attached device. wait time (in
seconds) Decoder
IP, serial command
HEX serialhex 1 169.254.17.88 43 4f 4d 4d
41 4e 44<┘ Y Y
serialhex Sends raw serial command (ASCII) to
device through N-Command. Wait time
determines time for N-Command to
automatically ask for the response from
the attached device. wait time (in
seconds), Decoder
IP, serial command
ASCII serialhex 1 169.254.17.88
"COMMAND"<┘ Y Y
readresponse Reads the response from a serial
command sent from N-Command where
the "Read Response" checkbox was
enabled when command is saved, or
where serialhex command is used. Decoder IP readresponse 169.254.17.88<┘ Y Y
volume Sets the Decoder’s volume level (0-100). Decoder IP volume 169.254.225.39 50<┘ Y Y
sendir Executes IR command saved on
Decoder. Reference is by name and is
case sensitive. Decoder IP,
command name sendir 169.254.212.1 Play<┘ Y N