Super Systems CarbCALC II User Manual

Page 46

CarbCalcII Configuration

CarbCalc II

CarbCalc.ini file : This file will be located in the same directory that contains CarbCalcII.exe (the
application directory). This file is used to configure some operating modes, and database locations
and external database structure.

The General section

TID = xxxx (where xxxx = a 4 digit TrialID number. Do not remove this number, you may lose your
registration.)

RTMONITOR=x (where x=0 or 1. When set to 1, puts CarbCalc in a Replay/Monitor mode using
CCLoads Database)

BMIntegration=x (where x=0 or 1. When set to 1, puts CarbCalc in a BatchMaster Monitor mode
using and external Database)

The Databases section

Material=.mdb (where is the name of the material access database (default
carbcalc.mdb if not specified)

CCLoads=.mdb (where is the name of the CarbCalc Load access database
(default CCLoads.mdb if not specified)

Note: the database names may be filename only (assumes file is in the application directory) or full
path and filename.

The BMLoads section (only required when BMIntegration=1, ignored otherwise)

DSN= (where is the ODBC DSN)

T_LOAD= (where is the table name for the table containing the load information)

F_ID= (where is the field name for the numeric field containing the load ID)

F_LNAME= (where is the field name for the character field containing the load
Name)

F_FCE= (where is the field name for the character field containing the Furnace
Name)

F_TIMEIN= (where is the field name for the datetime field containing the Load Start
time)

F_TIMEOUT= (where is the field name for the datetime field containing the Load
End time)

F_LINFO= (where is the field name for a character field containing additional Load
Information)

F_COMMENTS= (where is the field name for a character field containing additional
LoadComments)

Sample Carbcalc.ini file

[General]
*trial ID
TID= 9638
RTMONITOR=0
BMIntegration=1

[DataBases]
Material=carbcalc.mdb
CCLoads=C:\ssi\data\CCLoads.mdb

[BMLoads]
DSN=BM1
T_LOAD=Loads