Super Systems CarbCALC II - Manual (Page 18)

CarbCalcII CarbCalc II 17
© 2005,2006,2007 Super Systems Inc.
2.6 Parts and Loads
2.6.1 Loads
CarbCalcII comes with a Part and Load database. The user interface with the database varies
depending on the operating mode,
· CarbCalcII in Control Mode - Loads and Parts integrated with Load Entry System.
· CarbCalcII in Monitor Mode - Loadfs and Parts for display and replay of data.
· CarbCalcII integrated with BatchMaster - BatchMaster Load database used for display and replay of
data.
2.6.2 Control Mode
The Parts and Loads dialog contains 3 tabs: New Loads, Completed Loads and Parts.
New Loads - This tab is used to build loads and add them to the Loads database. It is also used to
select a load to run.
(Note: Yous must be logged in with access level 2 or higher to use this screen)
· Load Name - A unique name to identify the Load. You may use the drop list to select an existing
load or type in a new name for a new load. The drop list will only display loads that have not been
completed.
· Load Part - Select a part for the load (when a part is selected, the Model will change to the model
associated with that part.
· Qty - enter the quantity of parts in this load.
· Operator - (optional) enter an identifier for the operator
· Load Remarks - Optional remarks
· Model - Select the model to use for this load (model is selected when you select a part, but may be
changed using the droplist)