Super Systems 7EK 31080 - Manual (Page 29)

Appendix A.1
APPENDIX A
DEFAULT PARAMETERS
DEFAULT RUN TIME PARAMETERS
PARAMETER DEFAULT VALUE
SP = Initial scale value
SnRT = Disable
n.SRt = OFF
SP2 = Initial scale value
nnn = OFF
AL1 = Initial scale value for process alarm
0 for deviation or band alarm
HSA1 = 0.1 %
AL2 = Initial scale value for process alarm
0 for deviation or band alarm
HSA2 = 0.1 %
AL3 = Initial scale value for process alarm
= 0 for deviation or band alarm
HSA3 = 0.1 %
PB = 4.0 %
HyS = 0.5 %
ti = 4.00 (4 minutes)
td = 1.00 (1 minute)
IP = 30 % if one control output is
configured
= 0 if two control outputs are
configured
Cy1 = 15 seconds for relay output
= 4 seconds for SSR output
Cy2 = 10 seconds for P8 = AIr
= 4 seconds for P8 = OIL
= 2 seconds for P8 = H2O
rC = 1.00 for P8 = AIr
= 0.80 for P8 = OIL
= 0.40 for P8 = H2O
OLAP = 0
rL = Initial scale value
rH = Full scale value
Grd 1 = Infinite (step transfer)
Grd 2 = Infinite (step transfer)
OLH = 100 %
tOL = Infinite
Hbd = 50 % of the full scale value
SCA = 100% of the full scale value
rnP = Infinite
31080-A-00.p65 3/24/00, 11:58 AM 1