Super Systems MGA6000 - Manual (Page 40)

SSi Manual #4563 Rev. D Page 40 Multi-Gas Model 6000
2102 A/D Input 1 reading
2103 A/D Input 3 reading
2104 sensor reading
2105 PIC address
2106 bit 0 = Digital input 1 (PIC 0 only)
bit 1 = nu
bit 2 = Digital input 2 (PIC 0 only)
bit 3 = nu
bit 4 = PIC addr bit 0
bit 5 = PIC addr bit 1
bit 6 = Digital output; 0 = OFF (low), 1 = ON (high)
bit 7 = nu
bits 8 - 15 = version number x100
2107 Digital output control
2108 PIC A/D control
2109 read control
2110 zero read data from EErom
2111 span read data from EErom
2112 write control
2113 zero write data to EErom
2114 span write data to EErom
2115 read working register
2116 write working register
2117 Cell star value to send (2117 - 2118)
2119 Command to send to cell
2120 sensor start up timer (500ms increments)
2121 read SPI
2122 SPI data counter, high byte
2123 SPI store state 0 = normal operation (store)
1 = receiving data from boss, 2 = OK to send to Cell, 4 = sending to cell
2124 timer on SPI response, 10ms inc
2125 indicates SPI responded
2126 Last command used
2127 Result of the last command
* Registers 2128 to 2129 not used
* Data sent by IR cell in master mode
2130 decimal place //debug
2131 gas reading
* calc structure
2132 deg C (2132 - 2133)
2134 volts (2134 - 2135)
2136 atten (2136 - 2137)
2138 zero_volts_tc (2138 - 2139)
2140 span_volts_tc (2140 - 2141)
2142 atten_tc (2142 - 2143)
2144 curve_in (2144 - 2145)
* cal structure
2146 degCZ (2146 - 2147)
2148 degCS (2148 - 2149)
2150 Zero_volts (2150 - 2151)
2152 Span_Volts (2152 - 2153)
2154 ztc (2154 - 2155)
2156 stc (2156 - 2157)