Super Systems MGA6000 - Manual (Page 37)

SSi Manual #4563 Rev. D Page 37 Multi-Gas Model 6000
1900 copy of PIC_com_stat
1801 A/D Input 0 reading
1902 A/D Input 1 reading
1903 A/D Input 3 reading
1904 sensor reading
1905 PIC address
1906 bit 0 = Digital input 1 (PIC 0 only)
bit 1 = nu
bit 2 = Digital input 2 (PIC 0 only)
bit 3 = nu
bit 4 = PIC addr bit 0
bit 5 = PIC addr bit 1
bit 6 = Digital output; 0 = OFF (low), 1 = ON (high)
bit 7 = nu
bits 8 - 15 = version number x100
1907 Digital output control
1908 PIC A/D control
1909 read control
1910 zero read data from EErom
1911 span read data from EErom
1912 write control
1913 zero write data to EErom
1914 span write data to EErom
1915 read working register
1916 write working register
1917 Cell star value to send (1917 - 1918)
1919 Command to send to cell
1920 sensor start up timer (500ms increments)
1921 read SPI
1922 SPI data counter, high byte
1923 SPI store state 0 = normal operation (store)
1 = receiving data from boss, 2 = OK to send to Cell, 4 = sending to cell
1924 timer on SPI response, 10ms inc
1925 indicates SPI responded
1926 Last command used
1927 Result of the last command
* Registers 1928 to 1929 not used
* Data sent by IR cell in master mode
1930
decimal place //debug
1931 gas reading
* calc structure
1932 deg C (1932 - 1933)
1934 volts (1934 - 1935)
1936 atten (1936 - 1937)
1938 zero_volts_tc (1938 - 1939)
1940 span_volts_tc (1940 - 1941)
1942 atten_tc (1942 - 1943)
1944 curve_in (1944 - 1945)
* cal structure
1946
degCZ (1946 - 1947)
1948 degCS (1948 - 1949)
1950 Zero_volts (1950 - 1951)
1952 Span_Volts (1952 - 1953)