Sundance SMT410 v.1.0 - Manual (Page 8)

User Manual (QCF42); Version 3.0, 8/11/00; © Sundance Multiprocessor Technology Ltd. 1999
1 Introduction
The SMT410 is a single site module carrier board that provides access to a TIM
module over the PCI Mezzanine Card bus.
An on-board JTAG controller allows systems to be debugged using Code Composer
Studio. This JTAG controller also has buffered outputs that can be accessed using
connectors on the carrier’s back panel. This allows off-board devices to be connected
into the JTAG chain.
A single buffered ComPort with conflict protection is also available on the chassis
back panel. This will have the versatility to access all six ComPorts on the TIM.
The main connection to the PCI bus is via the module Global Bus. A single ComPort
is also be mapped to the PCI bus providing support for application boot and data
transfer.
A 1 MB of SRAM is mapped on to the Global Bus and can be accessed by the TIM as
a global resource or by the PCI Bridge.
The board requires a 3.3 volt supply, which is generated from the 5 volt supply that is
taken from the PMC connector, and is made available at the fixing pillars for the
module.