Sundance SMT387 - Manual (Page 10)

Version 1.0.3 Page 10 of 42 SMT387 User Manual
5. Replace the carrier board in the host system or power on for a stand-alone
carrier.
SMT387 + DSP TIM
You can fit the SMT387 coupled with a DSP module on any of Sundance carrier
boards: Stand alones or plugged in a Host.
Please, follow these steps to install the SMT387 module and the DSP TIM on a
carrier:
1. Remove the carrier board from the host system or turn the power off for a stand-
alone carrier.
2. Place the SMT387 module onto one of the TIM sites on the carrier board.
• Preferably, fit the DSP TIM on the first TIM site. This TIM site
communicates with the host. (See your carrier board User Manual.).
This allows the processor board to handle the interactions with the
Host.
• Fit the Comport communication links between the DSP TIM and the
SMT387 respecting the rules on polarity at reset. (See your carrier
board User Manual.)
3. Make sure that the board is firmly seated, and then provide the 3.3V to the board
by screwing the SMT387 on the two main mounting holes with the bolts and
screws provided with the board.
4. Connect the SHB links if required by your application.
5. Replace the carrier board in the host system or power on for a stand-alone
carrier.