6) adding 180º u-bend (etu only), 7) adding optional u-bend reflector (etu only) – Space Ray ETS Series User Manual

Page 27

Form 43343300

-26-

May 2013

10.6)

ADDING 180º U-BEND (ETU ONLY)

Hang tube sections parallel with each other. The centerline distance from tube at each tube section should

be 18” as shown.

Join tube ends of tube sections and the U-Bend together and secure with tube couplings as described in

Section 10.1).

(457mm)

Tube Coupling

U-Bend

Self-Drilling Screws

(QTY-2 per coupling)

10.7)

ADDING OPTIONAL U-BEND REFLECTOR (ETU ONLY)

Place the UUUU----Bend Reflector

Bend Reflector

Bend Reflector over the reflectors of each tube section with the end resting next to the tube wire

hangers as shown.

Slide the speed clips on the reflector edges towards the end of the tube section reflectors. Two speed clips

are required for each side of the U

U----Bend Reflector

Bend Reflector

Bend Reflector. Make sure that the speed clips fit tightly over both the U

U----

Bend Reflector

Bend Reflector and the reflector on each tube section. Use two self-drilling screws to permanently secure
both sides to the reflectors.

Place the End Reflector

End Reflector

End Reflector flush with the U

U----Bend Reflector

Bend Reflector

Bend Reflector as shown. Note:

Note:

Note: Clearance between end of the U

the U

the U----

Bend Reflector

Bend Reflector and the U

U----Bend

Bend

Bend must be a minimum of 1

1”. Secure by sliding speed clips onto the end

reflector edges. Evenly space the speed clips on the sides (two each side) and top (three each) of the
reflectors to provide a snug fit.

Speed Clip

Part No. 02266010

(QTY-7)

U-Bend Reflector

Part No. 43490000

Wire Hangers

Speed Clip

Part No. 02266010

(QTY-4)

End Reflector

Part No. 43490050

#10 Self-Drill Screws

Part No. 02189020

(QTY-4)

1 Clearance

(between end reflector

and u-bend)

This manual is related to the following products:

ETU Series