Space Ray ETS Series User Manual
Page 23
Form 43343300
-22-
May 2013
10.1)
ASSEMBLY OF EXTENSION SECTIONS
MIN 8 MAX 10 BETWEEN HANGERS
1
2
Tube Support/
Hanger Bracket
Wire Hanger
Coupling
U-Bolt Clamp
& 5/16 Hex Nuts
Tube Support/
Hanger Bracket
3
6 approx.
See typical assembly overview (Section 8.0) for typical complete assembly. Assemble additional extension
sections as required for all systems. (See Sections 7.0) and 8.0) for typical layout details.)
Join the tube sections together and secure with tube couplings as described below:
T
TT
The following
he following
he following
he following coupling
coupling
coupling
coupling tightening instructions MUST
tightening instructions MUST
tightening instructions MUST
tightening instructions MUST be
be
be
be
followed properly to ensure the integrity of the tube
followed properly to ensure the integrity of the tube
followed properly to ensure the integrity of the tube
followed properly to ensure the integrity of the tube
connections. Two #10 self
connections. Two #10 self
connections. Two #10 self
connections. Two #10 self----drilling screws
drilling screws
drilling screws
drilling screws MUST
MUST
MUST
MUST b
b
b
be installed
e installed
e installed
e installed
at every coupling as shown in the instructions below. Failure
at every coupling as shown in the instructions below. Failure
at every coupling as shown in the instructions below. Failure
at every coupling as shown in the instructions below. Failure
to do so may result in serious injury or property damage.
to do so may result in serious injury or property damage.
to do so may result in serious injury or property damage.
to do so may result in serious injury or property damage.
1.
Place the compression coupling over the end of the tube.
2.
Use the small hole at the centerline of the coupling to check that the coupling is inserted correctly.
3.
Partially tighten the bolt nearest the end of the tube (approximately half closed).
Tube
Coupling
1
Center end of
Tube with hole
Partially tighten this bolt
Tube
2
3
4.
Slide the next tube into the coupling.