SOMFY TILT WIREFREE RTS - Manual (Page 7)

1) Press the DOWN directional button on the transmitter. Blind will tilt
to the pre-set DOWN limit.
Press hold
MY (stop) Button
Press and
hold DOWN
Button
my
Press &
hold UP
& DOWN
Button
my
my
Press &
hold Either
UP or DOWN
Button
my
my
my
my
1.
2.
4.
3.
OPTION THREE Re-adjusting Lower Limit (DOWN Slat Position)
2) Once blind stops at pre-set down limit, press and hold the UP and
DOWN buttons simultaneously on the transmitter until the blind jogs.
3) Press and hold either the UP or DOWN button on the transmitter to adjust
slats to new position.
4) Press and hold the MY (Stop) button until blind jogs.
New lower limit (Down Stop Position) is now added to memory
Operating Instructions are for use with Telis 1&4, Decora 1&4 or Modulis Chronis Timer
my
my
USER MODE: Operating the Blind (tilting the slats)
Telis & Decora Switch Only
1. Press and hold the (UP) button to open the blind slats.
Release the button when the desired position is reached.
Blind slats will operate at ½ speed or press momentarily
on the UP button, blind slats will move to the programmed
limit (slat position) at full speed.
Telis Modulis Decora
2. Press and hold the (DOWN) button to close the slats.
Release the button when the desired position is reached.
Blind slats will operate at ½ speed or press momentarily
on the DOWN button, blind slats will move to the
programmed limit (slat position) at full speed. Telis & Decora Switch Only
Tilt WireFree RTS Programming & Operation Instructions TM
7