SOMFY TILT WIREFREE RTS - Manual (Page 3)

Press MY (stop)
Button
my
Press MY (stop)
and UP Button
4.
3. 3) Press the MY (Stop) button when the blind reaches the desired lower
limit (slat position). If necessary, adjust the desired slat position
with a brief press of either the UP or DOWN button.
4) Once desired lower limit (slat position) is reached, press and hold
MY (Stop) and UP buttons simultaneously until the blind begins to
tilt upward, then release.
my
Press MY (stop)
Button
5.
my
5) Once blind stops at previously set upper limit (slat position), press
the MY (stop) button for 2 seconds until the slats jog. This confirms
both limits (slat positions).
To complete programming proceed to STEP FIVE
1.
2.
Starting with slats in up (closed) position
1) Press and hold the DOWN or UP button on the transmitter
to reach the desired upper limit (slat position).
2) Once the desired upper limit (slat position) is reached, press and hold
the MY (Stop) and DOWN buttons simultaneously until the
blind begins to tilt downward, then release.
Press and
hold UP or
DOWN Button
my
my
Press MY (stop)
and DOWN Button
my
5.
Press MY (stop)
Button for 2 seconds
5) Once blind stops at previously set lower limit (slat position), press the
MY (stop) button for 2 seconds until the slats jog. This confirms both
limits (slat positions).
To complete programming, proceed to STEP FIVE
Tilt WireFree RTS Programming & Operation Instructions TM
3