SOMFY TILT WIREFREE RTS - Manual (Page 5)

my
Press and
hold UP or
DOWN Button
1. 1) Press the UP or DOWN directional button on the previously addressed
transmitter until the blind slats reach a desired intermediate position, then
press the MY (Stop) button to stop. If necessary adjust the desired slat
position by pressing and holding either the UP or DOWN button.
OPTION ONE Setting an Intermediate Position (IP)
STEP SEVEN Resetting Motor (Erasing all Previously Programmed Limit Settings and Channels)
Deleting Specific Channels/Transmitters
1) Using a paperclip or pen, press and hold the PROGRAM button on the
previously addressed transmitter until the blind jogs.
2) Select the desired channel (1-4 or all) or transmitter (single channel)
to be deleted.
3) Press and hold the PROGRAM button on the transmitter until the
blind jogs. Channel or transmitter is now deleted from the blind memory
and will not operate blind.
Previous
transmitter
Program
Button
my
Channel
Selector
To delete all previous settings: Using a paperclip, press and hold
the PROGRAM Button, located on the top of the motor casing, until
the blind jogs (3) times (approx. 12 seconds).
All transmitters and limits will be erased from the motor memory.
(Motor is now reset to factory mode). Motor limits (slat positions) will
need to be reestablished.
Tilt WireFree RTS Programming & Operation Instructions TM
5
1)