SOMFY TILT WIREFREE RTS - Manual (Page 2)

Tilt WireFree RTS Programming & Operation Instructions TM
STEP FOUR Setting Limits (Slat Positions)
1.
2.
my
Press MY (stop)
Button
3.
4.
my
Press MY (stop)
and UP Button
my
Press MY (stop)
and DOWN Button
Starting with slats in down (closed) position.
1) Press and hold the UP or DOWN button on the transmitter
to reach the desired lower limit (slat position).
4) Once desired upper limit (slat position) is reached, press and
hold the MY (Stop) and DOWN buttons simultaneously until the
blind begins to tilt downward, then release.
3) Press the MY (Stop) button when the blind reaches the desired
upper limit (slat position). If necessary, adjust the desired
slat position with a brief press of either the UP or DOWN button.
2 ) Once the desired lower limit (slat position) is reached, press and hold
the MY (Stop) and UP buttons simultaneously until the
blind begins to tilt upward, then release.
my
Press &
hold UP
or DOWN
Button
my
Check Polarity (blind direction) MUST BE DETERMINED BEFORE SETTING BLIND LIMITS STEP THREE
Press and hold the DOWN button and confirm the blind tilts down.
Press and hold the UP button and confirm the blind tilts up.
·If blind direction is correct, continue to Step 4.
·If blind direction is not correct (in reverse), press and hold
the MY (Stop) button on the transmitter for 2 seconds.
Blind will jog. Blind direction is now corrected. Blind
movement should now correspond to the direction button
on the transmitter.
my
my
my
my
Telis Modulis Decora
2