SOMFY TILT WIREFREE RTS - Manual (Page 6)

Press and hold
My (stop) Button
my
4. 4) Press and hold the MY (Stop) button until the blind jogs.
New Upper Limit (Up Stop Position) is now added to memory.
my
Press &
hold UP
& DOWN
Button
my
my
Press &
hold Either
UP or DOWN
Button
my
2.
3.
2) Once blind stops at pre-set up limit, press and hold the UP and DOWN
buttons simultaneously on the transmitter until the blind jogs.
3) Press and hold either the UP or DOWN button on the transmitter to adjust
slats to new position.
my
Press MY (stop)
Button
3.
Press and
hold UP
Button
my my
1. 1) Press the UP directional button on the transmitter. Blind will tilt to
the pre-set UP limit.
Note: Blind should be stationary prior to activating intermediate position function. If slats
are actively moving (in-motion) the MY (Stop) button should be pressed twice.
To Delete: Activate blind to (IP) position, then press and hold the MY (Stop) button for 5 seconds.
3) Activate the blind intermediate position by pressing the MY (Stop) button
from ANY slat position.
Re-adjusting Upper Limit (UP Slat Position) OPTION TWO
my
Press MY (stop)
Button for 2 seconds
2. 2) Press and hold the MY (Stop) button on the transmitter until the blind jogs.
Intermediate slat position is now added to memory
Tilt WireFree RTS Programming & Operation Instructions TM
6