beautypg.com

Programming the 844 sprayer control system – Smithco Spray Star 1607P (1999) Operator Manual User Manual

Page 18

background image

16

Operation

PROGRAMMING THE 844 SPRAYER CONTROL SYSTEM

SYSTEM SETUP MODE

The System Setup Mode contains the programming steps that customize the controller to the sprayer or
sprayer components. These include calibration steps and parameters that, once programmed, will likely never
change.

To enter the System Setup Mode, press and hold the

and

keys simultaneously. While holding the

and

keys in, depress the

key twice (within 3 seconds) to enter the System Setup Mode.

SETTING YOUR PROGRAM MODE (U.S., TURF)

Default = U.S.

1. The 844 console will display a large “US” in the center of the display. The default value “US” indicates

that all default values will be shown in U.S. measurements, unless changed to Turf (trF). Switching to
Turf units will cause the controller to display application rates in Gallons per 1000 ft².

2. If you will be using U.S. measurements no change is necessary, depress the

key to advance to the

next program step.

3. If, however, you will be using turf units, then depress either the

or

key to change from “US” to

“TURF” mode. Depress the

key to accept the value and advance to the next program step.

FLOWMETER PULSES

Default = 650

1. During the Flowmeter Calibration Step, the

!

symbol (flowmeter turbine) will be flashing at the top of

the console display.

2. First, locate the factory calibrated flowmeter pulse rate tag on the flowmeter. If this varies from the

default value of the console, use the

or

keys to modify the value. Depressing the

and

keys simultaneously will clear the value to zero.

PRESSURE BASED SYSTEM
Note:
If using a pressure based system, the 844 console will be preprogrammed for the pressure transducer
sold with the controller kit, and this programming step will not appear.

This manual is related to the following products: