Programming guidelines, Steps to successful programming – Smithco Spray Star 1607P (1999) Operator Manual User Manual

Page 17

Operation

PROGRAMMING GUIDELINES

IMPORTANT PRELIMINARY INFORMATION

Before you begin, we recommend that you review the following Programming Guidelines that control the pro-
gramming process.

1. For your convenience, the programming of the 844 has been divided into two programming categories;

System Setup Mode and Application Setup Mode.

2. Depressing the

key once will flash “P

“ in the upper left hand corner of the display window. The

word “USER” will be displayed in the lower right corner indicating you are about to enter the Application

Setup Mode. Depressing the

key a second time will put the Control Console into the Application

Setup Mode. If you inadvertently press the

key once, wait for 3 seconds and the Control Console will

return to its normal operating mode.

3. Depressing and holding the

and

keys while simultaneously pressing the

key once will flash

“P

“ in the upper left hand corner of the display window. The word “PrO” will be displayed at the left of

the display window indicating you are about to enter the System Setup Mode. Depressing the

key a

second time will put the Control Console into the System Setup Mode. A delay of three seconds will
return the Control Console to its normal operating mode. The System Setup programming steps will likely
only need to be programmed once, to customize the controller to your sprayer.

4. For either setup mode, if you depress and hold the

key for 3 seconds, your inputs will be stored and

the computer will exit the respective setup mode. This action will not be necessary until the last program-
ming step has been completed.

5. To increase the value of a programmable digit, depress the

key. To decrease the value, depress the

key. These keys are located directly to the right of the display.

6. For some programming steps, depressing and holding the

key will change the program-

mable value rapidly. Pressing the

key once will change the value by one increment.

7. Depressing the

and

keys simultaneously in some programming steps will set the value to “0”.

8. For either setup mode, depressing the

key will advance you to the next programming step.

STEPS TO SUCCESSFUL PROGRAMMING

TO BEGIN THE PROGRAMMING PROCESS:

1. Read above for programming tips.

2. Be sure the “master” boom toggle switch is “OFF.”

3. Turn console “ON” by pressing the

key. When the Control console is turned on, the software version

will be displayed at the top of the display and the serial number will be displayed in the lower left of the
display. This information will be needed when calling for service support.

This manual is related to the following products:

Spray Star 3007 Operator Manual