Smithco Sand Star I 45-001 Parts & Service Manual - Manual (Page 98)

B-27
Center Attachment
INSTALLATION INSTRUCTIONS
1. This product only fits on a Sand Star I and II. Will NOT fit on Sand Star III>
2. Center lift bar must be installed on our machine. This kit does not come with a lift bar.
3. If your center lift bar has castor wheels on it, you must remove the castor wheels and brackets.
4. Install Brush Motor Support (Ref 8) on your right side of center lift arm using the holes where the caster
wheel would bolt to. Bolt in place with hardware (Ref 7).
5. Place Hub Assembly (Ref 13) on brush (Ref 14) with the (Ref 13) hardware.
6. Place motor (Ref 11) on Motor mount (Ref 19) and then mount that assembly tot the Brush Motor Support
(Ref 8).
7. Connect the brush and hub assembly to the motor and tighten set screws.
8. Place adapter (Ref 10) into motor. The place the Coupler (Ref 5) on the inside adapter and the nipple (Ref
12) on the outside adapter.
9. Assembly the valve as shown in the drawing.
10. The Valve assembly mounts on the right front fender. The valve
goes underneath the fender with the handle pointing outward.
The valve mount plate (Ref 4) mounts on the outside of the
fender.
11. Mount the Single Bank Hydraulic Valve (Ref # 18) to the Valve
Mount (Ref # 4) as illustrated, using the two 5 /
16
- 18 x 2 Bolts
(Ref # 3). Secure with the two Lock Nuts. Connect the Straight
Handle (Ref # 2) to the Valve.
12. Connect 42" hoses (Ref 15) from the pump to the valve. Connect
the 21" hose from the valve to the cooler. The return hose on the
2-bank valve connects to the single bank valve.
13. Test operation of the broom before using on turf.