Smithco Sand Star I 45-001 Parts & Service Manual - Manual (Page 120)

C-49
Rear Attachment
13-740 SAND RAKE BRUSH KIT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-738 Brush, 89 x 11 1
2 13-737 Brush Channel 1
3 13-739 Brush Track 1
4 HB-14-20-075 Bolt 1 /
4
- 20 x 3 /
4
10
HNFL-14-20 Flange Whiz-Lock Nut 1 /
4
- 20 10
5 13-681 Mounting Brackets 2
6 HB-14-20-150 Bolt 1 /
4
- 20 x 1 1 /
2
4
HNFL-14-20 Flange Whiz-Lock Nuts 1 /
4
- 20 4
INSTALLATION INSTRUCTIONS
1. Place the Brush (Ref 1) into the Brush Track (Ref 3). Place the Brush Channel (Ref 2) between the brush
track and the mounting brackets. Now bolt the Mounting Brackets (Ref 5) to the brush track using the ¾"
bolts and flange whiz-lock nuts(Ref 4).
2. To mount the Brush Assembly (Refs 1-5) to the Rake Drawbar, first align the Mounting Brackets so the
Brush Assembly is centered ("X" measurements are equal) on the Rake Drawbar. Mark the locations for
the four holes that will need to be drilled.
Note: To fit the curve of the Rake Drawbar, a small amount of twist will
need to be put in the Mounting Brackets. This can be done by clamping the Mounting Brackets to the Drawbar.
3. Mount the Brush Assembly to the Rake Drawbar using the four 1½" bolts and flange whiz-lock nuts(Ref 6).