Skutch Electronics CK-1G1 - Manual (Page 2)

Page 2 of 3
2- Connect the short modular cord from [1&2 Phone on CK-1] to [LINE 1&2 on Phone].
3- Connect the short modular cord from [3&4 Phone on CK-1] to [LINE 3&4 on Phone].
4- Connect the audio cord from your music source, to the AUDIO IN jack on the back of
the CK-1 box. NOTE: If you are using a Digital Player, then use the audio cord that came
with your digital player. On this cord both ends have the same type of connector.
5- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1].
6- Connect a MOD cord from Telephone Wall Jack 3&4 to [3&4 Line on CK-1].
7- Locate the CK-1G1 DISPLAY BOARD, peel off the paper protector from the bottom
of the foam, and carefully align it as shown in FIG. 2. Once it is aligned properly, lightly
press down to attach it to the telephone.
8- Connect the Display Cable from the CK-1G1 Black Box to the Display Board that is
mounted telephone. See FIG. #3.
Fig. 2
Fig. 3
Fig. 2
Line up the dashes
on the DISPLAY BOARD
to the center of the
Line Select Buttons on
the phone.
Move the board towards
the right. The edge
should be touching the
edge of the buttons.
Attach Cable from Box