Skutch Electronics CK-1R4 - Manual (Page 2)

Page 2 of 4
Fig #2
Fit snug against
corner of phone.
3-
Connect the supplied Telephone Cord to [1&2 Phone] on CK-1, and the other end to the
jack [LINE 1+2] on the Phone.
4- Connect the audio cord from the AUDIO IN jack on the back of the CK-1 box, to your
audio source. If your audio source has an 1/8” phone jack, use the audio adapter on the
end of the cable.
This end goes into
CK-1R5 “Audio Input”
5- Run the Flat Gray Sensor Board cable underneath the base phone. Make sure that the
surface area of the base phone, where the sensor board is to be mounted, is clean and free
of all dust and oil film. Peel off the paper protector from the bottom of the sensor board,
and carefully place it OVER the LINE 1 and LINE 2 buttons on the RCA phone as shown
in Fig #2. The sensor board has been molded to fit against the lower right hand corner of
the phone. See Fig #2.
6- Connect the POWER CUBE from the CK-1 Silver Box to 115VAC power. That's it!