Scotsman NME954 - Manual (Page 30)

NME954 & FME1204
May 2001
Page 30
To Remove the Condenser Fan Motor
Assembly
1. Remove top panel and the two service panels.
2. Unplug the two fan motor wire leads from the fan
motors.
3. Remove the two hex head bolts from the top end
of the fan motor assembly.
REMOVAL AND REPLACEMENT: Fan Blade and Motor
Electrical shock hazard.
Electrical shock can cause
personal injury.
Disconnect power before
beginning to service
components.
4. Lift up the fan motors and bracket assembly about
½" and pull out the fan motor assembly out the right
service access hole.
5. Repair as needed.
6. To reassemble: Place the fan motor assembly
lower flange holes over the two allen head cap
screws in the base, and reinstall the hex head bolts
at the top of the assembly. Plug the fan motors back
in, and replace the top panel.