beautypg.com

Scotsman NME954 User Manual

Page 24

background image

WATER RESERVOIR
1. Shut off the water supply to the ice maker.
2. Remove front panel.
3. Remove reservoir cover.
4. Disconnect water inlet tube from reservoir inlet
fitting.
5. To remove float valve, push in “locking tabs” as
shown and pull float up.
Note: The plunger/seat is available separately as
a part.
6. To remove reservoir, pull up and remove water
sensor.
8. Disconnect water outlet tubes.
9. Remove mounting screws from reservoir
bracket, and remove reservoir from ice maker.
10. Reverse to reassemble.

BIN CONTROLS (Ice Level Sensors)
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate ice chute, at the base of the chute, in
front of and behind it are two plastic bin control
mounts.
5. Slide each bin control to the left, and disconnect
the electrical leads connecting the bin control to
the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the holes in the ice
chute.

NME954 & FME1204

May 2001

Page 24

LOCKING

TABS

FLOAT

ASSEMBLY

Water

Sensor

ICE

CHUTE

Slide Bin

Controls To

Remove

REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls

This manual is related to the following products: