Scotsman FM1200R - Manual (Page 38)

CIRCUIT BOARD TESTING
Water Level
1. Unplug “water sen” connector from control
board.
2. Plug “water sen” connector from Scotsman
tester into circuit board.
a. Move “water” switch on tester to No Water
position. The No Water light on the circuit board should go ON. If not, replace the circuit
board.
b. Move the “water” switch on the tester to the
Water position. The No Water light on the
board should go OFF. If not replace the circuit
board. If the light does go off, replace the
water level sensor.
LIGHT ON
WATER SENS
SWITCH TO
“NO WATER”
LIGHT OFF
SWITCH TO
“WATER”
FM1200R
November, 1988
Page 38