RGBLink VSP 198CVS Quick Start - Manual (Page 9)

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
8
How to Set up the SPLIT
SPLIT is used when multiple VSP 198CVS are used in cascade mode. When do cascade, connect the
signals to the signal distributor first, and then connect from the outputs of the signal distributor to each
input of VSP 198CVS.
The operations are as follows:
Push the SPLIT button, the button LED light will turn on, and enter the split function menus. Turn the
knob, and choose “SPLIT”, choose “ON” to enable the split function, menus are as follows:
H TOTAL: LED screen Horizontal total size.
V TOTAL: LED screen Vertical total size.
H POS: This device display image Horizontal size.
V POS: This device display image Vertical size.
H SIZE: This device display image Width setting.
V SIZE: This device display image Height setting.
RESET: If image quality distorts by improper operation, it can be recover by factory reset.
Save the parameters after setting.
Following is the example of cascade multiple VSP 198CVS for mapping.