How to do customized output resolution – RGBLink VSP 198CVS Quick Start User Manual

Page 10

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

Push the SCALE button, and enter the scale function menus, the OLED module show as follows, user

can adjust the following items by knob or number buttons.

H SIZE: Width setting.

V SIZE: Height setting.

H POS: Horizontal phase setting.

V POS: Vertical phase setting.

RESET: If image quality distorts by improper operation, it can be recover by factory reset.

Push [MENU] button to open the main menu, turn knob and go to , push knob and

confirm to go into the menu, as following:

STANDARD--Standard resolution.

CUSTOMIZED--Used defined resolution setting.

Push knob and go into menu:

1. Turn knob on each digital position, and change the value of the digital by the digital buttons on the

front panel.

2. After the digital, push the Knob will add *, means before * is the horizontal size. Same operation for

vertical size:

3. After the digital, push the Knob will add @, means before the @ is the vertical size, and after the @ is

the refresh rate. Only digital 50 or digital 60 supports for the refresh rate. Use the digital buttons to

finish the settings.

4. After input all the values, push knob to enable VSP 198CVS to output this resolution. VSP 198CVS

will take 5-10 seconds to enable this output resolution.