How to realize single image switching, How to set up the pip – RGBLink VSP 198CVS Quick Start User Manual
Page 8
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
7
How to Realize Single Image Switching
1. Boot the system default CV1 to the current input source, if need seamless switching other
source such as DVI, push DVI button.
2. CV1 button light turns off after pushing DVI button. DVI button light will be on if the DVI signal is
effective and stable. And if the DVI signal is invalid or no input, DVI button light will flash.The same
method can be switched CV2, VGA1, VGA2, DVI,HDMI, SDI.
Note: Only cut is supported among the switch of CV1, CV2, VGA2, HDMI and SDI.
Push the PIP button, button led light turn on, enter the PIP function menu.
LAYOUT: Can choose PIP layout, the corresponding results are as follows:
PIP L+T PBP L+R PBP T+B
SWAP IMAGE: It can set PIP to swap exchange, when choose ON, it can realize the IMAGE A and
IMAGE B exchange.
ALPHA: Can set the image transparency, the regulating range is among 0 to 16.
SELECT: Can choose to set the size or position of IMAGE A or IMAGE B individually.