C sending card installation, Sending card installation, Csending card installation – RGBLink Driver User Manual User Manual
Page 38
Driver User Manual 38
C
Driver controller equipped with a control panel, which compatible with different sending
cards. Before install the sending card, make sure choose the corresponding jumper cap
and seal with glue. The control panel shown in the figure below.
The following will instruct the sending card installation in detail, sending card types
include DBstar, Nova, Linsn and Colorlight.
1. DBstar Sending Card Installation
Before installation, user need to weld a needle that single row space 1.27 mm 9 pin in
blue box, shown as follows:
This manual is related to the following products: