Nixie tube can not display brightness value, Display shows no bottom half part, Led display shakes – RGBLink Driver User Manual User Manual
Page 35
Driver User Manual 35
Nixie tube can not display brightness
It usually occurs in Nova sending card. When Nova sending card
connected to PC software via USB, the key operation of control
brightness is invalid, and nixie tube will not display the brightness value.
User can only control the brightness via PC software or pull out the USB
cable to recover the key brightness controlling.
Display shows no bottom half part
Sending card does not support the bottom half part: There are limits
for different sending cards. As for Linsn TS802, if output resolution is 1920
or higher, while every LAN port can support only 320 height LED screen,
more than this value need to add D mouth reticle, more than 640, need to
add more sending cards as cascade.
Sending card input recognition is not correct: It usually occurs in
DBstar sending card. It is normal before, but LED display shakes after
change the output resolution. Generally, it will normally operate if reboot
the device.