System overview, Introduction – RGBLink Driver User Manual User Manual
Page 20
1. Introduction
System Overview
Driver User Manual 20
Driver controller is the only piece of equipment between the video
source and LED screen. The device takes a digital video (DVI) input
and converts it so it can be sent over a single CAT-5 (RJ45) cable to
the tiles. Compare with normal RJ45 connector, Driver use Ethercon
soft-patched connectors to make sure lock connection and better
protection for the CAT5 cable.
If using good quality cable, distances up to 100 meters (300 feet) are
easily achievable without the need for any signal booster. A single
Driver can drive up to 1280*1024 (2048*640) resolution (up to 142
pcs P6 tiles).
Driver is ready for cascade up to two pcs controller with push button
settings, and support much higher resolution application. The
mapping of each tile is also programmed with this controller, using a
user friendly PC application.