Research Concepts RC2000A - Manual (Page 19)

RC2000A Dual Axis Antenna Controller Chapter 2 Basic Functions 19
To configure the controller for AutoPol operation, the user must have a suitable output available on the
satellite receiver which is connected properly to the AutoPol input of the RC2000A. Additionally. the
polarity of the AutoPol input must be specified (from CONFIG mode), and the AutoPol feature must be
enabled (also from CONFIG mode). When the polarity of the AutoPol input is specified, the user is
informing the controller that a given AutoPol input level (high or low) corresponds to vertical polarization.
Configuring the AutoPol system during installation is covered in more detail in Chapter 3 and the
CONFIG mode prompts which enable and specify the polarity of the AutoPol input are described in
Chapter 4 in the CONFIG mode section.
Research Concepts, Inc. • 5420 Martindale Road • Shawnee, Kansas • 66218-9680 • USA www.researchconcepts.com