Remotec ZTS-100 V2.04 - Manual (Page 28)

Frequently Asked Questions
Q Why won't my ZTS-100 work with the Z-Wave devices I purchased from another
country?
A Due to different countries regulations Z-Wave products from different regions are set
to different frequencies. Before purchasing new devices make sure you have
checked to see that the device is compatible in your region.
Q Do I need an electrician to install ZTS-100 in my house?
A It is recommended to install this product by a qualified technician.
Q How do I know which product is compatible to my ZTS-100?
A ZTS-100 should work with any Z-Wave controller or gateway that has control
capability for "Thermostat" devices. You can check either the specifications in the
manual of your ZTS-100 or also check
roducts also come with
the Z-Wave logo.
Q Can I use 2 or more ZTS-100 in my house? What is the max. units if yes?
A Yes and it is very depends on the capability of gateway / controller. For example,
gateway can supports up to 8, 16 or 32 ZTS-100 in a network.
Q Where can I keep up to date with the latest Z-Wave products for my house?
A You can keep up to date by visitin
website where we will
have information and ideas for using Z-Wave technology.
Q What are the operation for Swing and Differential set point?
A Below are the detail explanations.
HEAT mode: thermostat controls the temperature according to the following diagram
o o o Example for Heating: (Set point = 70 F, Swing = 1 F, Differential = 2F)
o o => 1st stage heater turns on when room temp is 69 F and off at 71 F.
o o => 2nd stage heater turns on when room temp is 67 F and off at 70 F.
online at www.remotec.com.hk for a full list of
products that can be used with your ZTS-100. All Z-Wave p
g the www.remotec.com.hk
Diff Swing
SD= switch differential
Swing
Temperature
Output
Off
Heat
st 1 Turn off
nd 2 Turn off
Set point
st 1 Turn on
nd 2 Turn on
27