REMKO WPM-Smart-Control-Manual for users-WKF-180 User Manual
Page 23

"Settings" menu item (continued) - User
Level 2
menu item
Level 3 menu item
Level 4 menu item
Info
Floor
heating cycle
Time programme A
Level for programming various
different timer programmes for
the underfloor heating heating
cycle
Time programme B
Time programme C
Room temperature reduc-
tion
Parameter for adjusting the target
room temperature with reduced
operating mode (active with auto-
matic operating mode)
Heating curve adjustment
Parameter for adjusting the
heating curve for the underfloor
heating heating cycle. Adjustment
parameter base point / standard
inlet temperature and standard
outside temperature. REMKO
recommendation: Adjustment in
accordance with heating load cal-
culation
Heat pump
Basic settings
Output restriction
Currently without value range!
Graduated tariff
Number of power tariffs
Level for adapting various dif-
ferent power tariffs (high and low
tariff)
See left for possible adjustment
parameters
Time field Tariff 1
Time field Tariff 2
Power tariff 1
Power tariff 2
PV power utilisation
Power tariff 1
Only usable in conjunction with a
PV system.
See left for possible adjustment
parameters
Feed-in tariff
Personal use tariff
"Messages" menu item
Pressing "OK" (right softkey) takes you to submenus of the menu item "Messages".
This is where operating messages, warning notices and fault messages are displayed.
Explanation of symbols:
Warning message
Fault message
If one of these symbols appears in the header of the control screen, please access the menu item "Mes-
sages" and display the details, with instructions on how to rectify the fault, with the key on the right.
Operating messages indicate which of the regular operating statuses the system is in.
23