REMKO WPM-Smart-Control-Manual for users-WKF-180 - Manual (Page 20)

"Information" menu item (continued) - User
Level 2
menu item
Level 3 menu item Info
Heat pump
Heat pump status
Level for the temperature display
as well as the operational modes
of the REMKO heat pump
Further information via the infor-
mation button
Remaining idle time
Defrost status S22
Compressor status S21
Fault status S20
Target temperature A44
Enable signal
Disable compressor A30
Heat pump mode A31
Disable signal S16, energy supplier cut-off
Heat pump therm.output
Middle storage tank temp. S09
Max.inlet temperature
Heat pump therm.energy
Cont. HW offset
Cont. heating offset
Short-term HW offset
Short-term heating offset
Auxiliary
heat gener-
ator
Heat generator status Level for the display values of
one of the electrical heating ele-
ments installed in the heat pump
(single energy source operation
REMKO Smart-Serv EDP no.
259020).
Potential-free output A32
REMKO Smart WP-MANAGER
20