REMKO WPM-Smart-Control-Manual for users-WKF-180 - Manual (Page 22)

"Settings" menu item (continued) - User
Level 2
menu item
Level 3 menu item Level 4 menu item Info
Heating /
cooling
Mode
Room climate mode
Parameter for defining the oper-
ating mode. Automatic, heating,
standby or cooling possible
Difference from cooling
limit
Parameter for adjusting the target
room temperature
Difference from heating
limit
Parameter for adjusting the
heating limit temperature
(summer mode without cooling
function)
Cooling
Time programme
Parameter for adjusting the time
program for the cooling cycle
Cooling curve adjustment
Parameter for adjusting the
cooling curve depending on local
building conditions
Building adaptation Inertia of the heating curve
Parameter for adapting the
heating curve to the outside tem-
perature
Heater
heating cycle
Time programme A
Level for programming various
different timer programmes for
the heating cycle heaters
Time programme B
Time programme C
Room temperature reduc-
tion
Parameter for adjusting the target
room temperature with reduced
operating mode (active with auto-
matic operating mode)
Heating curve adjustment
Parameter for adjusting the
heating curve for the heating
cycle heaters. Adjustment param-
eter base point / standard inlet
temperature and standard out-
side temperature. REMKO rec-
ommendation: Adjustment in
accordance with heating load cal-
culation
REMKO Smart WP-MANAGER
22