REMKO WPM-Smart-Control-Manual for users-WKF-180 - Manual (Page 18)

"Information" menu item (continued) - User
Level 2
menu item
Level 3 menu item Info
Solar
Pump A01 / Pump control signal A40
If a solar plant is to be controlled
via the Smart Control controller,
the different current tempera-
tures of this system should be
listed here by sensors installed
Collector temp. S01
Lower storage tank temp. S02
Storage tank charging status
Storage tank changeover valve A12
Current output
Solar yield
Medium flow rate 1 S23
Inlet temp. S03
Return temp. S04
Hot water
Circulation pump A04
Level for the temperature detec-
tion for the hot water preparation,
as well as any circulation pump
to be controlled
Circ. actual temp. S05
Circulation request S05
Hygiene function (legionella circuit)
HW request
HW storage tank set temp.
HW storage tank actual temp. S08
Lower storage tank temp. S02
Hot water energy
Solar heating
Solar heating Information on whether solar
heating is possible
Only active with installed solar
plant as well as incorporation of
the heating system into the
existing heating cycle
Hot water temperature
Storage tank temperature, centre S09
Inlet temperature S13
Heater
heating cycle
Abs. pump speed A42
Level for the temperature detec-
tion of an unmixed heating cycle
(heater)
Display value only visible if this
heating cycle has been installed
Rel. pump speed A42
Heating cycle set temp.
Heating cycle actual temp.
Mixed outside temperature
Heating energy
REMKO Smart WP-MANAGER
18