REMKO RVD 351 DC - Manual (Page 6)

Operation
infrared remote control
The infrared remote control sends
the programmed settings over a
distance of up to 6 m to the re-
ceiver of the indoor unit. Data will
only be received correctly if the
remote control is pointed at the re-
ceiver and no objects are obstruct-
ing the transmission path.
First insert the supplied batteries
(2 x type AAA) into the remote
control. To do so, pull off the flap
of the battery compartment and
insert the batteries according to
their polarization (see marks).
The indoor unit is easy to operate using an infrared remote control. This is supplied as standard. The indoor unit
beeps to acknowledge the correct transmission of data. If it is not possible to program
the indoor unit using the remote control, it can also be manually operated.
Problems are
shown in code
(see chapter Troubleshooting
and Customer service).
CAUTION
Immediately replace flat batter-
ies with a new set, otherwise
there is a risk of leakage. It is
recommended that the batteries
are removed if the equipment is
shut down for long periods.
NOTE
max. 6 m
Maximum distance
Manual operation
The indoor units can be started
manually. Press the RESET button
on the receiver unit of the cover to
activate automatic mode. In manual
operation, the following settings
apply:
Cooling mode: 24 °C,
Fan speed AUTO
Heating mode: 26 °C,
Fan speed AUTO
Pressing any button on the infra-
red remote control interrupts
manual operation
Display on indoor unit
Unit for receiving signals
from the remote control
Operation-
screen
Alarm display
Display on indoor unit
The lit display LEDs indicate the settings.
LED H red = high fan speed
LED M yellow = medium fan speed
LED L green = low fan speed
Timer-
screen
fan
Defrost
REMKO RVD...DC
6