beautypg.com

Remko rvd...dc, Heating- mode heating mode operational sequence, Functional diagram – REMKO RVD 351 DC User Manual

Page 10

background image

HEATING-
MODE

Heating mode operational sequence

> 6 Min.

> 3 Min.

> 6 Min.

30 sec.

30 sec.

Nominal temperature +5 ℃

Nominal temperature +2 ℃

Fan operation IT

Fan operation AT

Compressor operation AT

Actual temperature

Stop heating
operation

Heating mode
Start heating
mode

Functional diagram

Operation

Stop

Reverse flow valve

30 sec.

30 sec.

During the defrosting cycle, the indoor unit vaporiser fan and the out-

door unit liquefier fan are switched off.

After the cycle is concluded, the fans are switched to their

previous settings.

< 7 Min.

Defrost period

15 sec.

60 sec.

Fan operation IT

Fan operation AT

Compressor operation AT

Operation

Stop

Reverse flow valve

30 sec.

30 sec.

30 sec.

3 Min.


AND

MODE

In the heating mode, you can heat the room in spring or fall. The desired

room temperature is set with the

/ buttons in 1 °C increments. If the

room temperature is 1 °C below the selected target temperature, the in-

door unit starts to heat the air in the room. The inverter controller checks

the difference between the adjusted target temperature and the actual

room temperature.

In the event of a greater difference, a higher cooling performance is created.

In the event of a smaller difference, a lower cooling performance is created.

This serves to maintain the air discharge temperature and the room tempera-

ture.

If the adjusted room temperature is still exceeded by approx. 2 °C, then

the control system turns the heating function off. To protect the com-

pressor, the regulation only turns the heater on again after a waiting

period of 3 minutes.

In heating mode, the indoor unit fan motor is switched on after a delay,

in order to prevent the discharge of cold air.

The fins on the outdoor unit could crack at low outdoor temperatures.

Regular reversal of the cooling circuit results in a defrosting action. The

display shows "H1" during the defrosting period.

HEATING Mode

FAN

20

10:49

TEMP

CLOCK

SPEED

HEAT

LOW

°

C

2i

10:49

TEMP

CLOCK

SPEED

DRY

AUTO

°

C

2i

10:49

TEMP

CLOCK

SPEED

HEAT

LOW

°

C

23

10:49

TEMP

CLOCK

SPEED

HEAT

LOW

°

C

23

10:49

TEMP

CLOCK

SPEED

HEAT

MED

°

C

REMKO RVD...DC

10

This manual is related to the following products: