QuickLabel CU-30 - Manual (Page 28)

24
13 Reposition the solenoid assembly on the cutter
blade shaft, leaving a small gap (approximately
1 /
16
inch) between the cutter housing the the solenoid
assembly.
14 Rotate the clutch assembly gear until the clutch’s
rotational stop rests against the solenoid stop.
15 Secure the solenoid assembly on the cutter blade
shaft by using an Allens wrench to tighten the two
set screws against the flats on the shaft.
rotational stop
install set screws
at 90
°
angles