Quantum Composers 9730 Series - Manual (Page 28)

9-28

Verify the rear panel Safety Interlock.
 Turn Arm Switch to ‘ARM’ Position.

Press the FUNC key and then the PRE
key (‘.’ on the numeric keypad) to run the
pre pulse resistance test.

Refer to Testing Mode Error Conditions for more information on any resulting
errors.
Post Pulse Resistance Testing
The 9730 allows the user to setup a post pulse resistance test that, when enabled, may
be run at any time to verify the resistance of the connected load is greater than a user
specified minimum. To use pre pulse resistance testing:

Setup the system mode, period and channel pulse parameters as described in
the Standard Operation Modes section.

In the Channel Test Menu:
o Set P stTest to ‘Enabled’
o Set PstMin to the minimum resistance expected for a “fired” device.

Verify the rear panel Safety Interlock.
 Turn Arm Switch to ‘ARM’ Position.

Press the FUNC key and then the POST key (‘.’ on the numeric keypad) to run
the post pulse resistance test.

Refer to Testing Mode Error Conditions for more information on any resulting
errors.
Testing Mode Error/Status Conditions

Status - “No Error Detected” – This message is returned through a channel
error query whenever no errors are detected for the current channel. Refer to
Channel Commands for more information channel queries.