Quantum Composers 9250 Series - Manual (Page 40)

9250 Manual Version 1.2 | Quantum Composers
40
:CMODe
NORMal / SINGle /
BURSt / DCYCle
Allows the user to select the
pattern of outputs to use on
the channel level.
:BCOunter 1 to 1,000,000
When the channel is in Burst
mode will allow user to select
the number of pulses to
output with each input clock
pulse.
*Note: The commas should
be omitted.
:PCOunter 1 to 1,000,000
When the channel is in duty
cycle mode will allow the
user to select the number of
pulses to create with each
input clock pulse.
*Note: The commas should
be omitted.
:OCOunter 1 to 1,000,000
When the channel is in duty
cycle mode will allow the
user to select the number of
pulses to suppress with each
input clock pulse.
*Note: The commas should
be omitted.
:WCOunter 0 to 1,000,000
Allows user to select how
many clock cycles to wait
until the channel should start
creating an output pulse.
*Note: commas should be
omitted.
:CGATe DIS / LOW / HIGH
Channel Gate Subsystem.
Contains commands to
control using the gate input to
control the output channel.
Command Keyword 1 Keyword 2 Keyword 3 Parameter Range Notes
:SYSTem
Command to change the
units’ system settings.
:STATe ? Query Only Command
:BEEPer
Command to change the
units’ beeper settings.
:STATe 0/1 or OFF/ON
Command to turn on or off the
systems' beeper.
:COMMunicate
Command to set the
communication settings.
:USB
:ECHo 0/1 or OFF/ON
Command to Enable/Disable
the echo function on the RS-
232 interface. The Echo
function will cause the unit to
repeat the command received
to the PC.
:BLUEtooth