Quantum Composers 9250 Series - Manual (Page 16)

9250 Manual Version 1.2 | Quantum Composers
16
Basic Operation
The following steps must be carried out before communication with the 9250 may take place:

Ensure that the proper drivers have already been installed on the remote computer.
These drivers will need to be installed for the remote computer to interface to the 9250.
Reference the “9250 Setup  USB” section for more information on installing the proper
drivers.

Open the 9250 application by double clicking on the application which can be found on
the included CD.

Once the 9250 application recognizes the COM Port the 9250 is attached to, a
connection will be established, and communication may now be carried out.

A COM Port does not need to be selected as the computer will automatically recognize
the 9250. If multiple 9250 units are connected to the same computer, multiple instances
of the GUI may be run. The first application instance will connect to the 9250 on the
lowest COM Port, followed by the next application connecting to the 9250 on the next
highest COM port.
*Note: Parameters on the GUI that are not applicable with the selected settings will be greyed
out and won’t be able to be adjusted until the appropriate settings have been selected.
(Example: The System’s Burst Count cannot be adjusted until the System is set to Burst
Mode.)
System Section
The System Section of the 9250 application only affects the 9250
’s system parameters. As
shown below in Figure 6.2, the following system parameters may be altered:
Figure 6.2 –9250 Application: System Parameters