beautypg.com

Start up and commissioning, Dual digital module technical guide 10, General – Orion System Dual Digital Module User Manual

Page 10

background image

Dual Digital Module

Technical Guide

10

Start Up and Commissioning

General

In order to have a trouble free start-up, it is important to follow a few
simple procedures. Before applying power for the fi rst time, it is very
important to run through a few simple checks.

One of the most important checks to make before powering up the system
for the fi rst time is to make sure that the VCM-X Modular or VCM-X
Modular E-BUS Controller is confi gured properly for your application.
Refer to the VCM-X Controller Technical Guide or VCM-X Modular
E-BUS Controller Technical Guide
for more information.

A handheld Modular Service Tool, Modular System Manager, or System
Manager Touch Screen connected to the VCM-X Modular or VCM-X
Modular E-BUS Controller will allow you to confi gure your application.
Refer to the VCM-X Operator’s Interfaces Technical Guide or System
Manager TS Technical Guide
for more information.

Check all wiring leads at the terminal block for tightness. Be sure that
wire strands do not stick out and touch adjacent terminals. Confi rm
that all sensors required for your system are mounted in the appropriate
location and wired into the correct terminals.

WARNING: Observe polarity! All boards must be wired

GND-to-GND and 24 VAC-to-VAC. Failure to

observe polarity could result in damage to the

boards.

Table 1: Unit Confi gurations Chart

UNIT CONFIGURATIONS

PERMUTATION

CIRCUIT A

CIRCUIT B

HARDWARE

VCM-X WSHP

CONFIGURATION

Comp A1

Comp A2 Comp B1

Comp B2

Relay 1

Relay 2

Relay 3

Relay 4

1

Fixed

N/A

Fixed

N/A

Use VCM-X

Modular Series
Controller Only

2 Compressors

2

Digital

N/A

Fixed

N/A

Use VCM-X

Modular Series
Controller Only

2 Compressors
Digital Compressor

3

Digital

N/A

Digital

N/A

Use VCM-X

Modular Series

Controller and

Dual Digital

Module

2 Compressors
Dual Digital

4

Fixed

Fixed

Fixed

Fixed

Use VCM-X

Modular Series
Controller Only

4 Compressors

5

Digital

Fixed

Fixed

Fixed

Use VCM-X

Modular Series
Controller Only

4 Compressors
Digital Compressor

6

Digital

Fixed

Digital

Fixed

Use VCM-X

Modular Series

Controller and

Dual Digital

Module

4 Compressors
Dual Digital