Orion System OE742-XX-VAVZ - Manual (Page 30)

Form: Orion-OE282-03-SlvZoneDmprKit-Sub-01A.doc
Page 1 of 1
Description
The OE282-03 Slaved VAV/Zone
Damper Kit consists of an OE282
Damper Actuator, (2) PL101824
Slave Wiring Interface Boards and
(2) 18” Long Modular Cables. The
OE282 Actuator is a shaft mounted,
floating point control actuator. The
actuator is a 24VAC/24VDC model
with a 10K ohm feedback signal for
position monitoring. Wiring
connection to the actuator is by
means of a modular phone cable
connector located on the actuator
cover. The actuator is rated for 45 in-
lb. of torque. All actuators are
electronically protected against
overload. The angle of rotation is
mechanically limited to 95
. When
the end position of the actuator or
damper is reached, the actuator
automatically stops. For adjustment
purposes, the gears can be
manually disengaged by pushing the
manual override button on the
actuator cover.
Applications
The OE282-03 Slaved VAV/Zone Damper Kit allows multiple dampers (up to 2 total besides the master) to be
connected to a master OE742-31-VAVZ or OE742-32-VAVZ P.D. VAV/Zone Controller Actuator Package. The
OE282-03 Kit is typically used when larger CFM requirements dictate multiple dampers are used. One of the
Interface Boards connects to the master VAV/Zone Controller via a modular cable. The other Interface Board
connects to the Slave Damper Actuator. Three conductor wiring is then routed and connected between the two
Interface Boards. For zones requiring more than one Slave Damper Kit a second one can be purchased and
installed in the same manner.
OE282-03
Slaved VAV/Zone Damper Kit
Technical Data OE282-03 Slaved VAV/Zone Damper Kit
Actuator Power
Supply 24VAC
 20% 50/60HZ Actuator Angle of Rotation
Max. 95
, Adjustable
Actuator Life Cycle
Rating 2.5 Million Cycles with Mechanical Stops
Actuator Power
Consumption 3 VA Maximum Power Connections RJ-11 Modular Jack
Operating Temp -22
F to 122F Servicing Maintenance Free
Operating Humidity 5 to 95% RH Non-
Condensing
Actuator Quality Standard ISO 9001
Actuator Overload
Protection Electronic Throughout 0
to 95
 Rotation
Actuator Agency Listings UL873 listed
CSA 4813 02 Certified
Actuator Feedback
Signal 10K ohm 1W
Potentiometer
Actuator Torque Minimum 45 in-lb.
Actuator Running
Time 80-110 Seconds. Approx. Kit Weight 2.2 lb.
PL1018224 Board (2) RJ-11 Modular Jacks PL1018224 Board (2) Wiring Terminal Blocks
Three Year Warranty WattMaster reserves the right to change specifications without notice