OpenEye CM-145 - Manual (Page 2)

Camera Adjustment
If you have trouble operating your camera, refer to the following table. If the information provided in this manual does not enable you to solve the prob-
lem, contact an authorized technician.
Nothing appears on the screen • Check that the power cord and connection between the camera and monitor are connected properly.
The image on the screen is dim • Is the lens dirty? Clean your lens with a soft, clean cloth.
• Change the monitor settings
• If the camera is exposed to too strong light, change the camera position.
• Adjust the lens’ focus.
The camera is not working properly, and
the surface of the camera is hot. • Check that you have properly connected the camera to an appropriate power source. If there is no
problem with the power, turn the unit off immediately and seek assistance from Customer Service.
The image on the screen fl ickers • Is the camera facing direct sunlight or fl uorescent lighting? Change the camera position.
Troubleshooting
Connection
Monitor and Power Connections
• The wire is non-polarized.
• Use 24vAC power source or 12vDC power source.
Note CM-145H requires a 24vAC power source.
A: Tilt rotation - Adjust the vertical angle.
B: Pan rotation - Adjust the horizontal angle.
C: Horizontal rotation - Adjust the horizontal position of the screen.
A
B
C
Hardware Kit Contents
• L-Wrench
• Service Monitor Cable
• Mounting Screw Kit
Installation*
1. Tape the guide pattern to the wall
or ceiling.
2. Drill four holes according to the
guide pattern and then insert
anchors into the drilled holes.
3. Pull the power / video cables to
the installation and connect to the
camera.
4. Attach the camera to the mounting
surface using the supplied screws.
5. Adjust the camera using the 3-axis
gimbal by hand.
6. Put the dome cover over the base.
7. Attach the dome cover to the base
using the supplied L-Wrench.
• Rubber Camera Housing Pad
• Installation Guide Pattern
* Prior to installation, consult local building code requirements