5 load-balance policy – Draytek 2910 User Manual
Page 45
Vigor2910 Series User’s Guide
39
D
D
e
e
t
t
a
a
i
i
l
l
s
s
P
P
a
a
g
g
e
e
f
f
o
o
r
r
P
P
P
P
P
P
To use PPP (for 3G USB Modem) as the accessing protocol of the internet, please choose
Internet Access from WAN menu. Then, select PPP mode for WAN2. The following web
page will be shown.
PPP Client Mode
Click Enable to activate this mode for WAN2.
SIM PIN code
Type PIN code of the SIM card that will be used to access Internet.
Modem Initial String
Such value is used to initialize USB modem. Please use the default
value. If you have any question, please contact to your ISP.
Modem Dial String
Such value is used to dial through USB mode. Please use the
default value. If you have any question, please contact to your ISP.
PPP Username
Type the PPP username (optional).
PPP Password
Type the PPP password (optional).
Index (1-15)
Set the PCs on LAN to work at certain time interval only. You may
choose up to 4 schedules out of the 15 schedules pre-defined in
Applications >> Schedule setup. The default setting of this filed is
blank and the function will always work.
3
3
.
.
1
1
.
.
5
5
L
L
o
o
a
a
d
d
-
-
B
B
a
a
l
l
a
a
n
n
c
c
e
e
P
P
o
o
l
l
i
i
c
c
y
y
This router supports the function of load balancing. It can assign traffic with protocol type,
IP address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or
WAN2 interface. The user can assign traffic category and force it to go to dedicate network
interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when both WAN1 and WAN2 are activated.