OpenEye E-Series Slim - Manual (Page 47)

32705AB 47
Network Setup
Configure network settings.
Network
HOST NAME – Host name for the recorder on the network.
NETWORK TYPE – Select STATIC IP to manually define a static IP address. Select DHCP
for a DHCP server to assign an IP address automatically. Contact your network administrator
for more information.
IP ADDRESS – You can set the IP ADDRESS if your network type is set to STATIC . Contact
your network administrator for this information.
CLIENT CONFIGURATION – Set up the connection ports and Max transfer speed for remote
connections.
CENTER PORT – E-Series recorders use the Center port and the primary
communication port to create remote connections. This port must be the same
as the port setting on the remote PC.
VIDEO PORT
–E-Series recorders use multiple ports to create remote
connections. The remote port is user-defined (default 2000), and a secondary
port is automatically assigned (default 2002). The recorder assigns the
secondary port based on the remote port, in increments of two. (For example, if
you set the remote port to 2222, then the secondary port will be 2224.) Verify
that all these ports are available when setting up Network Address Translation
(NAT) or firewall.
WEB PORT
– Defines the port that Internet Explorer uses to connect over the
web and view video. If this port is changed then the new port must be defined
when attempting to web connect. (For example, if your IP address is 10.0.0.5
and you change the web port to 800, then you must type http://10.0.0.5:800 in
your browser.)
MAX TRANSFER SPEED – Set network bandwidth. This feature is used for
slower internet connections to throttle the amount of data the recorder sends
across the network at a time.
Network Setup continued